DEBUGGER AND SIMULATOR COMMAND SETS
These are the most commonly used commands for both the debugger and simulator:

Command	Action
reset	Resets the debugger or simulator.
load <drive:/path/filename.out> load <drive:/path/filename.dsk>	Load a <.out> program. (Simulator and Debugger) Load a <.dsk> program. (Debugger only)
file <path/filename.asm> file <path/filename.c>	Load a source file. (Simulator only)
quit	Quit the debugger or simulator.
F1 Help	Invokes the Help screen.
F2 Reg40	Display the content of the CPU registers in 40-bit hex format.
F3 Float	Display the content of the CPU registers in float format.
F5 Run	Runs the loaded program until halted by any key pressed.
F8 SStep	Single step through the loaded program.
mem <addr> memx <addr>	View the content of memory at specified address in 32-bit hex.
memi <addr> (integer) memd <addr> (double) meml <addr> (long)	View the content of memory at specified address in signed format.
memui <addr> memud <addr> memul <addr>	View the content of memory at specified address in unsigned format.
mm <addr>	Modify the memory content at address.
mm <addr>, length, value	Fill the memory starting at <addr> to <addr + length - 1> with value.